Lako Tool's patented Hot Chamber Punch™ (HCP™) is widely used in the packaging industry for punching strong, neat holes in polypropylene (OPP)
bags on vertical FFS baggers.
With State-of-the-Art Heater Control Technology (US Patent No.5,451,288)
Advantages of Lako's Hot Chamber Punch™
Use lighter, less expensive films and still get the same on-rack hole strength as achieved with heavier films.
With lower film costs, this hole punch system will pay for itself over and over again.
Far less maintenance than mechanical hole punches; no need for frequent change of hole punch and anvil due to wear.
Lako's patented design nearly eliminates heat transfer from the hole punch to the crimper (no hot spots in the crimper seal area).
In most applications, the hole punch is self-cleaning; the center of the hole stays attached to the bag.
The Hot Chamber Punch™ conveniently plugs into Lako's electronic Hot Chamber Punch Control™ (HCPC™). The Hot Chamber Punch Control™ accurately and consistently controls the hole punch tip temperature.
Comes with complete installation and application instructions.
Benefits of Lako's Hot Chamber Punch™
Installed in crimpers sealing jaws, the Hot Chamber Punch™ actually melts a hole in the bag while sealing and annealing the perimeter of the hole.
The Hot Chamber Punch Control™, an electronic temperature control, maximizes hole punch heater life and maintains a constant hole punch tip
temperature, independent of load or crimper temperature.
We also offer a Quick-Change hole punch assembly that lets you change from standard crimping to hot hole punch crimping in just 15 minutes,
without removing or replacing heaters or temperature probes.
Contact us for more information on our Hole Punches, our Hot Chamber Punch™, or our Hot Chamber Punch Control™, or for a proposal on your next package sealing project!
|
|
